Neopixel Óra Firmware Feltöltése - Arduino ESP8266 D1 Mini

NTP Server-Based Neopixel Clock
morvfer
Site Admin
Hozzászólások: 10
Csatlakozott: 2017. május 15., hétfő 15:49

Neopixel Óra Firmware Feltöltése - Arduino ESP8266 D1 Mini

Hozzászólás Szerző: morvfer » 2017. június 6., kedd 19:58

Új program az órához:

New program for the clock:

Az óra, perc és másodperc színei maradtak piros, zöld és kék.

The colors for the hour, minute, and second hands remain red, green, and blue.


Ami új, hogy az óra az éjszakai időszakban 35% fényerővel világít.

What's new is that the clock will now shine at 35% brightness during the nighttime hours.


Az éjszakai időszak hétközben 21:30-tól reggel 6:15-ig tart,

hétvégén pedig 21:30-tól 9:30-ig.

The nighttime period is from 9:30 PM to 6:15 AM on weekdays,

and from 9:30 PM to 9:30 AM on weekends.


Erre a módosításra azért volt szükség, hogy éjszaka így nem világítja be a szobát, de a pontos idő leolvasható ilyen fényerővel is

This modification was necessary so that the clock does not illuminate the room too much at night, but the accurate time can still be read at this brightness

Aki 2017. június 1. előtt vásárolt tőlem órát, annak még a régi program fut.

For those who purchased a clock from me before June 1st, 2017, their clock is still running the old program.

Ha szeretnéd lecserélni a programot az új verzióra, írj egy e-mailt és küldöm az új bináris tartalmat.

If you would like to upgrade your clock to the new version, please send me an email and I will send you the new binary content.

A Wemos D1 mini a CH340 meghajtót igényli. Ezt windowshoz itt találjuk meg, ha telepítettük, akkor csatlakoztatás után egy új COM portot kapunk. Ennek a száma gépenként eltérő lehet, általában a legmagasabb lesz a megfelelő.

The Wemos D1 Mini requires the CH340 driver. You can find it for Windows here. After installing it, when you connect the board, a new COM port will be assigned. The number of this port may vary on different computers, but it's usually the highest number available.

A firmware feltöltésére az Espressif saját programozóját használhatod.

You can use Espressif's own programmer to upload the firmware.

Az alábbi videón bemutatom a feltöltést:

I will demonstrate the firmware uploading process in the following video:



Válasz küldése

Ki van itt

Jelenlévő fórumozók: nincs regisztrált felhasználó valamint 0 vendég